Zero Drop Tester

Product Item : ZYDT-830
Category： Paper, Packaging & Print
zero drop tester
drop tester
Drop Test Machine
Product description：The zero drop tester is mainly used to investigate the impact of drop impact on packaging during actual transportation and loading and unloading, and to evaluate the impact strength and rationality of
INQUIRY

Product Introduction

The zero drop tester is mainly used to investigate the impact of drop impact on packaging during actual transportation and loading and unloading, and to evaluate the impact strength and rationality of packaging design during handling.

The zero drop tester is mainly used for large package drop tests. The machine is equipped with an "E" shaped fork that can be quickly moved down as a test holder and according to the test requirements (surface, edge, angle test). During the test, the support arm moves down at high speed and the test product falls onto the base plate rubber with an "E" fork. Under the action of high-efficiency shock absorbers, embedded in the base plate, theoretically, the zero drop tester can perform drop tests from the zero height range. The drop height is set by the LCD controller, and the drop test is carried out automatically according to the set height.

Control principle: The computer is introduced into the electrical rational design to complete the design of free fall, edges, corners and surfaces.

Applicable standard: GB/t1019-2008

Technical Data

Maximum sample weight	0-200Kg
Descend altitude	0-1500 mm
Maximum sample size	1600 × 1100 × 1000 mm
Impact floor dimensions	1800 × 1600 mm
Affect the bottom	1. One piece: 30 mm thick, flat: the height difference between any two points on the impact surface shall not exceed 1 mm; 2. Hard: The static load deformation of any 100 square millimeter area on the impact surface shall not exceed 0.1 mm
Sample lift speed	<20 s/m
The arm reduces the final speed	1m height, terminal speed > 4.42 m/s
Support arm size	1000 × 30 mm
Test side	Faces, edges, and corners
impetus	380V/50hz
Drive mode	Motor driven
protector	The upper and lower protections are equipped with inductive protection
Impact plate material	45# steel, solid steel plate
Height display	Touch screen control
Descend altitude	Touch screen control
Structure of the bracket arm	45# steel is made by welding
Drive mode	Taiwan imported straight slide and copper guide sleeve, 45# chrome steel
Accelerator	Pneumatic
Descending mode	Pneumatic
weight	About 1500 kg
Power rate	5 kW